Slam your speakers with a one-two combination of power and control with the Punch P4004 amplifier! With its innovative circuit design, MOSFET output stages, and proprietary technology, the P4004 will bring out extraordinary detail in your music, with ultra-clean power you just can't get from a lesser amp. You get 50 watts RMS by four channels to power two sets of full-range or component speakers or you can bridge the P4004 for 200 watts RMS x 2 for a pair of subs. (More)
Power 1-channel Amplifier (More)
7 reviews
Enjoy the tight, hard-hitting bass of the 5001 by KLH. It features a 12" polymer-coated woofer and a 12" polymer-coated passive radiator to provide ample bass. (More)
Frequency Response: 5 to 50kHz - Peak Power: 1200 Watt (More)
375W x 1 - 750 watts RMS x 1 at 2 ohms - Class D (More)
500W Adaptive Class D - 1,000W @ 2 Ohms - 1,500W @ 1 Ohm - Prizm EFX Control Panel (More)
45W RMS x 6 @ 4 ohm (12.5V); 75W RMS x 6 @ 2 ohm (12.5V) -- 90W RMS x 3 @ 8 ohm (12.5V); 150W RMS x 3 @ 4 ohm (12.5V) (More)
Features: Front Channels: 100 W RMS x 2 @ 1.5 ohm-4 ohm (11V-14.5V) Rear Channels: 25 W RMS x 2 @ 1.5 ohm-4 ohm(11V-14.5V) Subwoofer Channel: 250 W RMS @ 1.5 ohm-4 ohm (11V-14.5V) THD at Rated Power: S/N Ratio (F&R): >108.5 dB below rated power S/N Ratio (Sub): >95 dB below rated power Frequency Response (front and rear): 5 Hz-30 KHz (+0, -1dB) Frequency Response (sub channel): 5 Hz-500 Hz (+0, -1dB) Damping Factor (front and rear): >200 @ 4 ohm/50 Hz Damping Factor (sub channel): >500 @ 4 ohm/50 Hz Input Range: switchable from 200mV-2V RMS to 800mV-8V RMS Differential-Balanced Input Topology: (3 pairs of inputs) Front Crossover: fully-variable (50 Hz-5 KHz), selectable- slope BP or HP (12 or 24 dB per octave) Rear Crossover: fully-variable (50 Hz-5 KHz), selectable- slope HP (12 or 24 dB per octave) Sub Crossover: fully-variable (40-200 Hz), selectable-slope LP (12 or 24 dB per octave) Preamp Output: 2-channel (full-range or LP) Bass EQ: Variable boost up to 15db Infrasonic Filter: defeatable 24dB/octave at 30 Hz Left minus Right Ambience Circuit: ambient effect for rear channels Front and rear speaker output connections: accept up to 8ga. wire Dual mono subwoofer output connections: accept up to 8ga. wire +12V and Ground connections: accept up to 4ga. Wire Dimensions: 19.7"L x 9.25"W x 2.36"H (More)
Outputs: 1 Pair - Peak Watts: 1200 x 1 - With Built-in Crossover - With Bass Boost - 80 db Signal to Noise Ratio (More)
This Class D amplifier features a variable bass boost circuit, which boosts the low-end response of your car audio system. auto amplifier,car stereo amplifier,infinity car amplifiers,infinity amplifier,infinity,circuit car amplifier,car bass amp,car... (More)