Ethernet splitter Networking Products

Description:

The Cisco POES5 5-Volt Power over Ethernet Splitter lets you put your Cisco Small Business IP Phones almost anywhere, by removing the requirement for a nearby power outlet. The POES5 sends power and voice over IP (VoIP) over one Category 5 cable to your Cisco phone. When it's time to add or relocate a phone, the POES5 can simplify your installation.The Cisco POES5 provides an 802.3af Power over Ethernet (PoE) port for connection to a PoE switch. The compact POES5 connects to the standard DC power input and RJ-45 Ethernet port on the Cisco IP phone (or other supported Cisco Small Business VoIP product) via two "split" cables. The POES5 can then be tucked away and concealed in the stand attached to the Cisco Small Business IP Phone.Simplify your installation and place your Cisco Small Business IP Phones, or any of the other supported Cisco Small Business VoIP products, in a preferred spot with the Cisco POES5 5-Volt Power over Ethernet Splitter.

Description:

TRENDnet s TPE-102S Power over Ethernet Splitter provides an innovative and cost effective solution to a variety of Ethernet devices such as VoIP phones or Wireless Access Points. Reduce costs by using existing CAT5 cable to deliver both power and data where power source is difficult to obtain

Description:

Power Over Ethernet (POE) integrates data and power over standard Ethernet cabling. It is a way to supply reliable, uninterrupted power to network cameras in hard to access places using Category 5 cable. Power Over Ethernet technology saves the time and cost of installing separate power cabling and AC outlets for each network camera.The IPCAMPOESPLIT, POE Splitter connects to the DC Jack and RJ-45 port of the Network Camera. A Cat-5 cable runs from the POE Splitter to a POE Switch to a maximum of 100 meters. One IPCAMPOESPLIT is required per Network Camera.The IPCAMPOESPLIT will supply a 12V maximum 1A precision regulated output. 4XEM Power Over Ethernet adapters have built-in ESD/lightning protection to help in preventing equipment damage due to transients and also have proprietary sensing algorithms which detect an overload or short circuit condition and shut down the supply to prevent equipment damage.The IPCAMPOESPLIT is rated for operation at -10 to +60 deg C and up to 90% humidity, and will perform reliably in outdoor weatherproof enclosures.Using Power Over Ethernet will allow you to locate your power supply at a central location where it can be attached to an uninterruptible power supply (UPS). The IPCAMPOESPLIT will connect your Network Cameras to a Power Over Ethernet Switch like the EPOEMS12, 4XEM's 12 port Power Over Ethernet MidSpan Switch.

Description:

D-Link, an industry leader in networking, introduces the DWL-P200 Power over Ethernet (PoE) Adapter. The DWL-P200 delivers both data and electrical power to Ethernet-enabled devices using a single Ethernet cable. Using Power over Ethernet, you eliminate the need to place an Ethernet-enabled device, such as a wireless access point, near a power outlet, giving you more freedom in placement.The DWL-P200 Power over Ethernet (PoE) Adapter is simple to install, requiring no tools and no software. Its compact size makes implementation of the DWL-P200 easy. Plug the base unit into a power outlet, and then connect the terminal unit to your network device using any standard Ethernet cable. Once set up, the terminal device unit can output power to any compatible 5V or 12V Ethernet-enabled device.The DWL-P200 simplifies your installation of Ethernet-enabled devices, such as an Internet camera or wireless access points, by allowing you to place it beyond the range of standard power outlets. You can now mount these devices to a ceiling or outside without placing them near a power supply.With the DWL-P200 Power over Ethernet (PoE) Adapter, both power and data can be transmitted up to 328 feet (100m) using standard Ethernet cabling with virtually no reduction in data throughput. Use the DWL-P200 with Ethernet-enabled devices where power outlets are not readily available.

Description:

Axis High Power over Ethernet splitter offers an easy, fast and cost-effective solution for powering network video products - specifically PTZ (pan/tilt/zoom) and PTZ dome network cameras - without the need to install power outlets and electrical...

Description:

The Gigabit Power over Ethernet Splitter (TPE-112GS) splits a networked PoE signal into separate power and Gigabit data sources.This device allows administrators to run Gigabit speed PoE cables over long distances and then split the PoE signal into ...

Description:

The Gigabit Power over Ethernet Splitter (TPE-112GS) splits a networked PoE signal into separate power and Gigabit data sources.This device allows administrators to run Gigabit speed PoE cables over long distances and then split the PoE signal into ...

Description:

By using the DWL-P50, both data and electrical power can be delivered to a non-PoE Ethernet-enabled device from a single CAT5 Ethernet cable. By using the DWL-P50, both data and electrical power can be delivered to a non-PoE Ethernet-enabled device from a single CAT5 Ethernet cable.The DWL-P50 is simple to install and requires no tools or software. Multiple DWL-P50 terminal units complement any PoE injector unit or midspan switch to provide small to medium business settings a complete end-to-end PoE solution. In addition, this unit supports 802.3af ensuring compatibility with other 802.3af PoE compliant injector units or midspan switches. Its compact size makes implementation extremely easy. During setup, this terminal unit can be set to power up any compatible 5V or 12V Ethernet-enabled device via the volt selector located on the back. Using the convenience of Power over Ethernet, you eliminate the need to place an Ethernet-enabled device, such as a wireless access point or an Internet camera near a power outlet.

Description:

D-Link's DP-301P Fast Ethernet print server is a compact device that attaches to a parallel printer. This device permits the printer to print files from a large number of users connected over a Fast Ethernet network. Designed to work with the PC and Macintosh, this pocket-sized device saves users cost by doing away with the need to equip every workstation with a dedicated printer. Multiple computers can share a single printer; the print server queues users print files, allowing the printer to print them out in an orderly manner.Through the DP-301P, users connected over a network who access the Internet, run Windows 95, 98, 2000 or NT, access files from a Novell NetWare server, or run Unix, Linux or MacOS can all print files transparently from the shared printer. At one end of the DP-301P is a 36-pin high-speed Centronics parallel port that plugs directly to the printer without any need for printer cable. On the other end of the DP-301P is a 10/100Mbps dual speed LAN port that connects to either an Ethernet or Fast Ethernet network. This LAN port auto-detects the speed of the network (10Mbps or 100Mbps) and adjusts itself accordingly. This single-port print server is cost-effective and most suitable for a SOHO network. However, large workgroups with printers spread around in different locations can also benefit by setting up multiple DP-301P print servers.

Description:

www.axis.com Axis T8128 High Power over Ethernet splitter offer an easy, fast and cost-effective solution for powering network video products specifically PTZ (pan/tilt/zoom) and PTZ dome network cameras without the need to install power outlets and...

Description:

Simplify your network installations with power and data on one cable!The Linksys Power Over Ethernet Adapter Kit lets you put your access points almost anywhere, by removing the requirement of nearby power outlets. By using the existing Category 5 Ethernet cabling to deliver power to any standard 5 volt access point or other network device, you save the time, hassle, and expense of running AC power to the access point's installation location.The best position for a wireless access point is usually on the ceiling, in the center of the area to be covered. Second best would be high on a nearby wall. Unfortunately, there's usually no easily accessible AC power plugs available in these locations. With the Power Over Ethernet Adapter Kit, installing the access point in these preferred spots becomes far less trouble.The Power Over Ethernet Adapter Kit is a two piece set. The "Injector" sends both power and data over one Category 5 cable to your access point, wireless router or bridge. Then the tiny "Splitter", placed at the remote location, separates the network data and DC power back into two cables, and delivers them to the access point. The Injector can also be used by itself with POE-enabled network devices that accept 48 volts directly on a POE port.This product is a 12 Volt Power Over Ethernet adapter kit.

Description:

AIR802 POEPASS-01 is a Power-over-Ethernet (PoE) kit or set that allows low cost of delivering power over the network cable for shorter distances.

Description:

Power Over Ethernet (POE) integrates data and power over standard Ethernet cabling. It is a way to supply reliable, uninterrupted power to network cameras in hard to access places using Category 5 cable. Power Over Ethernet technology saves the time and cost of installing separate power cabling and AC outlets for each network camera.The POE Kit consists of an Injector that connects to an Ethernet Switch or Hub and to AC Power, and a Splitter that connects to the DC Jack and RJ-45 port of the Network Camera. A Cat-5 cable runs between the Injector and Splitter to a maximum of 100 meters. One POE Kit is required per Network Camera.

Description:

The 3Com Baseline Switch 2126-G is an unmanaged, fixed configuration Layer 2 Switch with 24 10/100 ports and two copper 10/100/1000 uplinks, designed for small to midsize offices. This rack mountable, business-class switch can be installed in a wiring closet or as a free-standing unit.The switch comes preconfigured for fast, easy installation using economical copper wiring. Auto-negotiation adjusts the port speed to match the communicating device. To simplify cable connections, all 26 ports come with automatic detection of the Ethernet cable type (MDI/MDIX).Like all 3Com Baseline products, this switch provides powerful practicality in a sturdy package designed for reliability, long life, and low total cost of ownership.

Description:

Format : Controller Weight : 3 lb(s)

Description:

With the use of Power over LAN Active Splitter, Axis network video products can receive both data and power over a single Ethernet cable. The Power over LAN (PoL) products enable Axis network cameras and video servers to be installed in areas where traditional power cabling and outlets are unavailable or difficult to install. Power over LAN offers an easier, faster and more cost-effective solution than installing new power outlets and electrical cabling.

Description:

Description:

Axis T8128 Power over Ethernet Splitter,

Description:

Manufacturer: Microsemi CorporationManufacturer Part Number: PD-AS-701/18Manufacturer Website Address: www.powerdsine.comProduct Name: PowerDsine 2-Pair Power over Ethernet Active SplitterOutput Voltage: 18V DC Universal none

Description:

LevelOne s POS-1000 is a POE splitter to integrate Power Over Ethernet (POE) technology to legacy appliance by just using a single Cat.5 Ethernet cable for both power and data transaction. The legacy equipments such as Wireless AP, NetworkCamera,...

Description:

LevelOne's POS-1000 is a PoE splitter to integrate Power over Ethernet PoE technology to legacy appliance by just using a single Cat 5 Ethernet cable for both power and data transaction. The legacy equipments which connect to POS-1000, all devices...

Description:

LevelOne s POS-1000 is a POE splitter to integrate Power Over Ethernet (POE) technology to legacy appliance by just using a single Cat.5 Ethernet cable for both power and data transaction. The legacy equipments such as Wireless AP, NetworkCamera,...

Description:

With the use of Power over LAN Midspan and Power over LAN Active Splitter, Axis network video products can receive both data and power over a single Ethernet cable. The Power over LAN (PoL) products enable Axis network cameras and video servers to be ...

Description:

With the use of Power over LAN Midspan and Power over LAN Active Splitter, Axis network video products can receive both data and power over a single Ethernet cable. The Power over LAN (PoL) products enable Axis network cameras and video servers to be ...

Description:

The Aggregating Span Taps can combine data from multiple Ethernet network segments into one stream of data. A single Gigabit device, such as an intrusion detection system, protocol analyzer, or network probe can receive the aggregated data with just...

Description:

The Linksys WAPPOE Power Over Ethernet Adapter Kit lets you put your access point almost anywhere, by removing the requirement of a nearby power outlet. It uses the existing Category 5 Ethernet cabling to deliver power to any standard 5 volt access point or other network device. The kit is a two piece set consisting of the injector and the splitter. The injector sends both power and data over one Category 5 cable to your access point, wireless router or bridge. And then the tiny splitter, placed at the remote location, separates the network data and DC power back into two cables and delivers them to the access point.

Description:

In-line taps install on LAN or WAN links between two network devices providing instantaneous access to layer 1-7 traffic. No configuration or switch resources are required when monitoring devices plug into taps for real-time analysis.In-line taps offer...

Description:

Axis T8128 High Power over Ethernet splitter offer an easy, fast and cost-effective solution for powering network video products specifically PTZ (pan/tilt/zoom) and PTZ dome network cameras without the need to install power outlets and electrical...

Description:

With the use of Power over LAN Midspan and Power over LAN Active Splitter, Axis network video products can receive both data and power over a single Ethernet cable. The Power over LAN (PoL) products enable Axis network cameras and video servers to be ...

Description:

The Aggregating Span Taps can combine data from multiple Ethernet network segments into one stream of data. A single Gigabit device, such as an intrusion detection system, protocol analyzer, or network probe can receive the aggregated data with just...